-
-
Mitchco reacted to ddude003's post in the thread Filter setting for crosstalk cancelation with
Like.
You might give a shout out to Mitch Barnett @Mitchco as well as have a look at his Hang Loose Convolver which seems to have some... -
Mitchco replied to the thread W11 stability.Hi Ofer, yes, I have been running AL under W11 for a couple of years with no issues. Same with HLC.
-
I'd say yes for Audiolense. There may be slightly more people who experiences measurement problems now than a couple of years back, but...
-
Ok. I think is sorted out. I reduced the sweep time from 7 seconds to 5 seconds and increased the memory allocation to 160% . I was...
-
Mitchco reacted to juicehifi's post in the thread How can I get Audiolense to import .mdat files? with Like.
Hi Joelha, This is not supported in Audiolense due to measurement quality consideration. It is very difficult to verify that REW...
-
Mitchco reacted to 2234rew's post in the thread Step response - my drivers are not time aligned with Like.
Hi @Mitchco I have 3-way DSP XO system. My drivers are not time aligned right? I need to do more work with the correction designer...
-
Mitchco reacted to juicehifi's post in the thread Step response - my drivers are not time aligned with Like.
Actually, this is a very good looking result. The step response stays close to theoretical perfection all the way here.
-
My target varies somewhat in the bass, depending on the capacity below 100 Hz. So I customize the roundoff and how low it goes. A...
-
Mitchco reacted to juicehifi's post in the thread Need help with "The channel setup is not supported by the sound card - Maybe too many channels?" error with Like.
Sadly that’s the truth.
-
Mitchco reacted to 2234rew's post in the thread Need help with "The channel setup is not supported by the sound card - Maybe too many channels?" error with Like.
You and friend need to get a better mic like EMX-7150 And use single interface for both DAC and mic pre/ADC - and therefore single ASIO...
-
[30 jan 2025] Implemented custom speakers for Atmos and waveformat setups, and for Atmos and waveformat playback formats. In other...
-
[07 jan 2025] The +10 dB amplification on low frequency effect wasn't enabled for Atmos setups. Now it is. Audiolense 6.28 (64 bit)...
-
-
Loading…
-
Loading…