-
-
FFSAF reacted to Sonnie Parker's post in the thread StormAudio ISP Elite MK3 Processor: Comprehensive Review and Setup—Exploring DLART with
Like.
The best way to determine this is to do both and then measure the results as I did. If the results are not improved with the multi-point... -
FFSAF replied to the thread StormAudio ISP Elite MK3 Processor: Comprehensive Review and Setup—Exploring DLART.I prefer a (rotating) superdirective microphone array to tune SIMO speakers to minimize wall reflections to get purer stereo. I mean...
-
FFSAF replied to the thread StormAudio ISP Elite MK3 Processor: Comprehensive Review and Setup—Exploring DLART.I am lost. What does EQ-ing with omnidirectional mics mean if our ears are not omni?
-
FFSAF replied to the thread FSAF (Fast subband adaptive filtering) measurement.Preferably, a setup shall be able to loop at every point, i.e.: - at application s/w - at the drivers - at the audio interface on the...
-
FFSAF reacted to John Mulcahy's post in the thread FSAF (Fast subband adaptive filtering) measurement with Like.
Because there is clipping somewhere along the path for higher levels. Stop over-driving the system or adjust gains to stop the clipping.
-
FFSAF replied to the thread FSAF (Fast subband adaptive filtering) measurement.That's better. I'd advise to increase the digital signal level to see where it breaks. On my 2i2, it starts to break when the...
-
-
FFSAF replied to the thread FSAF (Fast subband adaptive filtering) measurement.On my 2i2 Gen 3, white noise at -25dBFS RMS, balanced out -> balanced in : FSAF shall suppress the residual (aka THD+N) all the way...
-
-
FFSAF replied to the thread FSAF (Fast subband adaptive filtering) measurement.The previous version of it, PS130F, without Evo. This is how it behaves (H3 on 80 dBSPL@1m) with 0 | 6 | 12 | 24 Ohm series resistor...
-
-
FFSAF replied to the thread FSAF (Fast subband adaptive filtering) measurement.Confused = can't make much sense = can't explain. If I could explain, I would not be confused:-) Yes, including Focal PS130
-
FFSAF replied to the thread FSAF (Fast subband adaptive filtering) measurement.I did not know that about MOTU, thank you for sharing this very valuable insight! I also saw the correlations... but after I measured a...
-
-
FFSAF replied to the thread FSAF (Fast subband adaptive filtering) measurement.I have been playing with current measurements for quite a while but have not found a way to make much sense of them. First, you need a...
-
FFSAF replied to the thread FSAF (Fast subband adaptive filtering) measurement.I would second on EQ. That helps to compare different drivers "apples to apples"
-
FFSAF reacted to siarez's post in the thread FSAF (Fast subband adaptive filtering) measurement with Like.
It would be nice if EQ could be applied to FSAF measurement signal, similar to how you can do that with sweeps. It would be useful where...
-
FFSAF reacted to dcibel's post in the thread FSAF (Fast subband adaptive filtering) measurement with Like.
It's taken a long time to get to the root cause of my previous measurement inconsistencies plaguing this thread. It wasn't anything to...
-
FLooks like in its bare state the decay times are very long so you will need to change the IR truncation setting in the Analysis...
-
-
Loading…
-
Loading…
