-
-
Jjdelange replied to the thread Static noise, failed calibration using REW with Behringer UMC202HD Audio Interface.SOLVED I searched on YouTube for Latencymon uses and followed a guide to remove any latency problems. Since I am not allowed to include...
-
-
Jjdelange reacted to dlr's post in the thread Static noise, failed calibration using REW with Behringer UMC202HD Audio Interface with
Like.
I have no experience with this, but got curious about it. The Behringer site for this one has a comment similar to yours with a... -
Jjdelange replied to the thread Static noise, failed calibration using REW with Behringer UMC202HD Audio Interface.Thanks for the link. It's not all that clear, but the suggestion of different drivers for the device I have forwarded to the vendor...
-
Jjdelange replied to the thread Static noise, failed calibration using REW with Behringer UMC202HD Audio Interface.Attached the results. These were run without running REW at the same time.
-
-
Jjdelange reacted to John Mulcahy's post in the thread Static noise, failed calibration using REW with Behringer UMC202HD Audio Interface with Like.
Latencymon can show what stops your PC managing to maintain continuous audio data transfer. The higher the sample rate, the more likely...
-
Jjdelange replied to the thread Static noise, failed calibration using REW with Behringer UMC202HD Audio Interface.Done. Two lucky? shots, then back to errors. I repeated the 48 kHz measurement at the end. Now with the errors
-
Jjdelange replied to the thread Static noise, failed calibration using REW with Behringer UMC202HD Audio Interface.To add: when I send the level calibration tome to the built in speakers of the laptop, there is no static noise in the test tone. It is...
-
Jjdelange replied to the thread Static noise, failed calibration using REW with Behringer UMC202HD Audio Interface.Thanks for your feedback! Installed the patch, restarted the PC. Checked windows audio settings. Ran some tests. Same random timed...
-
Jjdelange reacted to John Mulcahy's post in the thread Static noise, failed calibration using REW with Behringer UMC202HD Audio Interface with Like.
Perhaps you are experiencing the Windows 11 USB audio bug, there is a fix available.
-
Jjdelange posted the thread Static noise, failed calibration using REW with Behringer UMC202HD Audio Interface in Official REW (Room EQ Wizard) Support Forum.I have recently purchased a Berhinger UMC202HD Audio Interface that I intend to use to analyze and tune audio hardware and speaker...
-
-
-
Loading…
-
Loading…
