John Mulcahy's latest activity
-
John Mulcahy replied to the thread REW Beta Release REW API beta releases.The Measure dialog is owned by the main REW window. It first appears centred on the position of that window, but you can move it... -
John Mulcahy replied to the thread REW Beta Release REW API beta releases.I have fixed that for the next build.
-
John Mulcahy replied to the thread REW Beta Release REW API beta releases.Yes, I have added that for the next build.
-
John Mulcahy replied to the thread FSAF (Fast subband adaptive filtering) measurement.Why such short window settings for your measurements? (2ms left and 5ms right).
-
John Mulcahy replied to the thread FSAF (Fast subband adaptive filtering) measurement.The system being measured rolls off sharply below 200 Hz, its impulse response reaches the noise floor after about 250ms. Asking the...
-
-
John Mulcahy replied to the thread REW Beta Release REW API beta releases.Builds updated today (beta 61) with these changes: Added: API /measurements/{id}/command entries to Wrap phase and Unwrap phase for a...
-
John Mulcahy replied to the thread FSAF (Fast subband adaptive filtering) measurement.The sweep noise floor plot takes into account the process gain applicable to the sweep length so that the noise floor plot can...
-
John Mulcahy replied to the thread REW Beta Release REW API beta releases.Sure, but it's either reduce the font size slightly or use a larger screen.
-
John Mulcahy replied to the thread REW Beta Release REW API beta releases.You can choose a smaller font in the View preferences.
-
John Mulcahy replied to the thread REW Beta Release REW API beta releases.The "-VA" form will be used in the next build. I have changed the behaviour so that individual measurements do not need to be saved to...
-
John Mulcahy replied to the thread Measuring capacitors and inductivities not related to speakers.You can change the graph start frequency in the View preferences. I don't have any advice on transformer measurement, sorry.
-
John Mulcahy replied to the thread REW multiple instances on Linux.That must be something the install4j launcher does. REW has it's own startup file, but it's only used to detect a failure to shut down...
-
John Mulcahy replied to the thread Is it possible to display total RMS of a measurement?.They are generated from the FFT data, taking into account window effects and the distortion high pass and low pass settings, if used.
-
John Mulcahy replied to the thread REW and Dayton IMM-6C calibration file load problem.Yes, that's right.
-
John Mulcahy replied to the thread REW and Dayton IMM-6C calibration file load problem.REW doesn't have the data required to support that mic. You can stop the message by removing the sens factor line from the cal file.
