Hi John, sorry but the original setup was the crossover board glued to the speaker wire push connector base and I just used the original as was in the new chamber and I never looked at the values to check. They are a pain to take apart to look at but will look for any information in other ways...
Also want to understand H chambers more as in someways they are a ~quasi open baffle. Have done lots of ..wierd chambers over the years and wonder how much 'tuning' of an H-box (if thought of in a 6th order bandpass way) could be gotten away with.
And Thanks for your info too...
When Peavey, Fender or others built guitar/bass cabinets (usually older versions) there would be a 'slot' opening on the back (on combo cabinets you would store the power cable there). That slot was usually full width side to side but only the center 'approximately a third' was open vertically...
Been hijacking this topic and this might be a little to the side of diy but use this setup as a reference once in a while to remember the past.
Open Baffle has been on my mind for a while and next project will likely be something in that area. Been researching how musical equipment manufacturers...
Had purchased the pieces from Madisound.com for this project but wanted to change up the default speaker,
(since everyone that built the box and used the Fostex full range driver ended up adding external tweeters on top).
Being an old Kef fan mainly due to the point source tweeters decided to go...
For those interested in more information on the JBL Paragon.
https://en.wikipedia.org/wiki/JBL_Paragon
(some of the inspiration for the monstrosity above, yea a closeted fan of Kenrick Sound too)
Yeah had gone to the RMAF a couple years in the early 2010's it was sad to see it go. Had lived in Seattle for a while and moved back here for the snow, cascade mountains the snow is like wet concrete and hard on old knees.
Matthew 5:28-30
Hello,
A bit about this train wreck. Am in the 6th decade and still upright most of the time, work from home for last 7 years with a place have been with for the last 13 years. Did car audio and electronics though the 1980's and early 1990's, switched to computer IT in mid 1990's and been doing...
Bought a set of very old Klipsch speakers from a public radio station and the enclosures were beat up and the grills looked like they had cats. Had some aperiodic chambers with grills that had built for a car project 20 years ago and never used. Had the thought to use the chambers as a...
Fascinated by the JBL Paragon speakers, set off on a path to make a miniature version as cheaply as possible. Starting with the cheapest amazon speakers possible but wanting 'point source' main drivers ended, up with DS18 speakers EXL-SQ4.0 mains and EXL-X6.4D dvc sub. Since didn't have room...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.