Recent content by socbutter

My streamer is Nvidia Shield Pro using my UNRAID NAS and Spotify as source.

Enter me to Win This sound bar would help clean up my living room,

Thank you.

I followed Jeff Mery's YT videos to run subwoofer sweeps for MSO to do its magic. Things I did after getting the "High measurement distortion" warning: Replaced all cables Ran multiples sweeps with different AVR Volumes and Sweep Levels Sweeps made in dedicated HT with double entry door Reduce...

Are you asking about where to place your subs? If that is the case, Ive found it easier to place the sub in my MLP and using REW and placing the mic in various locations while taking sweeps at those locations. I think is called reciprocity. Else you could use Obsessive Compulsive Audiophile...

Thank you for the videos. A few questions: 1 set subs in same location for measurements and keep mic at MLP? 2 set AVR volume at the level I listen to media (do not change) 3 I can use REW's Tone generator? Set to NOISE + PINK RANDOM + Sub Cal (30-80Hz) + Output Channel 4: Subwoofer? 4 I have...

Got my sub sweeps for all 8 positions without any change in volume while measuring the subs. I still don't get how it could have changed the first time.

This morning I changed the Sweep Level to -21.0dBFS from -12.0dBFS and kept the AVR volume @-14.0 (my normal listening volume). This gave me a reasonable output of 76dB. I'll run my subwoofer sweeps later. If successful I will run Audyssey to get the remaining speakers (7 bed layer and 4 ATMOS...

I am used a miniDSP 2x4HD (2x4HD) and REW's Check Level to matched my 4 subs to 75db before taking Multi-Point (8) measurements sweeps. I was successful in taking measurements at 3 positions for 4 subs (@75dB), but at position 4 when checking levels it register 106dB. All sequence Check...

I followed the Audyssey A.R.T. video with two screens. ON one screen I followed the tutorial and on the second screen I performed the work shown on the tutorial. It is a long laborious task, but the results are beautiful to my ears.

The language in the video is English is with a German accent. Sorry you could not understand accented English.:(

Increased ASIO buffer to maximum, Ran REW v5.20.14. This did not work, Uninstall REW V5.20.14 and installed REW V5.20.13 Ran REW but microphone volume too low Increased UMM-6 Volume level to 100% in WIN10 RAN REW SUCCESSFULLY:jump: I think everything is good, but I would like someone with more...

I switched out all the cables non-active USB extension, active USB extension, new and old umm-6 USB-A TO USB-B 2.0 cable, no extension cable, new HDMI cable, my wife's Laptop and a new umm-6 Microphone. I'm now getting the Clock adjustment too large and High Measurement Distortion windows when...

@sam_adams I've used non-active USB cable always, but I'm will try an active USB cable tomorrow.

I replaced both USB extension cable and the umm-6 USB-A TO USB-B 2.0 cable. I also tried a different USB connection on my laptop. This is the result> As soon as the new Dayton Audio UMM-6 USB Microphone arrives later today I'll give that a try.