Thiele-Small Parameters measurement using dual added mass method.

miniDSP and AV Nirvana
S

sm52

Member
Joined
Mar 14, 2019
Posts
1,018

jcandy​

Hello. There is a question how to fix the driver during the measurement of parameters. The driver must be positioned vertically in the air. The question is how to fix it correctly? Intuitively, it seems that the driver should be fixed through the holes in the basket that the manufacturer made for this, to some kind of structure that can hold the driver so that there are no obstacles around the driver. But on your videos and pictures, the driver is fixed by a magnet. In some cases, there are solutions when the driver is fixed to the housing by a magnet, and the basket is fixed in the hole by pressing. But in most cases, the drivers are fixed to the case through holes around the circumference of the basket. So how to properly fix the driver so that there are no parasitic vibrations during the measurement?
 
S

sm52

Member
Joined
Mar 14, 2019
Posts
1,018

John Mulcahy​

I measured a driver that has very low sensitivity. About 80 dB. During measurements, the sweep was very quiet. It's usually louder. Can the measurements be trusted in this case? Should there be a dependence of the level of the measuring signal on the sensitivity of the driver being measured?
 
John Mulcahy

John Mulcahy

REW Author
Joined
Apr 3, 2017
Posts
8,169
Dual added mass measurements include a Bℓ curve, it should be close to horizontal around the resonant frequency if the measurements are good.
 
S

sm52

Member
Joined
Mar 14, 2019
Posts
1,018
Thank you. The parameters include Lp. In my case it is 80.24 dB (1W/1m). The help doesn't describe what it shows. I couldn't find a description of it on the Internet. Does it have anything to do with driver sensitivity?
 
John Mulcahy

John Mulcahy

REW Author
Joined
Apr 3, 2017
Posts
8,169
It is the calculated power sensitivity, but it is generally better to use the manufacturer's figure.
 
jcandy

jcandy

Registered
Joined
Dec 3, 2017
Posts
13
Location
San Diego
To answer your question in post 77 about measurement level, the usual advice is to say that for good comparison with linear theory, the level needs to be high enough to have a good S/N ratio, but low enough to avoid nonlinearity. Practically this means something between 10mV and 500mV for 3in-8in drivers. For larger drivers and for modeling high-power applications, you will of course want higher voltages. Is there a specific question about Speakerbench?
 
You must log in or register to reply here.
miniDSP and AV Nirvana

Popular tags

20th century fox 4k blu-ray 4k uhd 4k ultrahd action adventure animated animation bass blu-ray calibration comedy comics denon dirac dirac live disney dolby atmos drama fantasy hdmi 2.1 home theater horror kaleidescape klipsch lionsgate marantz movies onkyo paramount pioneer rew romance sci-fi scream factory shout factory sony stormaudio subwoofer svs terror thriller uhd ultrahd ultrahd 4k universal value electronics warner warner brothers well go usa
Top Bottom