linuxonly
Member
Thread Starter
- Joined
- Jul 27, 2024
- Messages
- 82
More
- Preamp, Processor or Receiver
- Logitech Z906
- DAC
- AMD FCH Azalia
- Computer Audio
- SPDIF output with alsa, pipewire, wireplumber on Fedora 40
- Streaming Equipment
- Kodi
- Front Height Speakers
- 33 in
- Middle Height Speakers
- 30 in
- Rear Height Speakers
- 57 in
- Video Display Device
- X11/VGA + X11/DVI
Hi,
How do you compare measurements from the same MLP, same room, same furnitures before and after creating IR filters and applying filters with CamillaDSP? Does it takes a separate computer with REW?
I'm asking because I took a new set of measurements and made certain by monitoring with helvum and Camillagui that the measurement signals from REW were routed through the speaker filters. I compared that with my initial measurements I made 1 day earlier without any DSP treatment.
I expected to see what should have been corrected (A/B). Since I can hear the diffference, and it's hige, I imagine I would see it too. To my surprise, the curves were identical. Once smoothed to 1/6, they were still perfectly superimposed!
Am I missing something?
How do you compare measurements from the same MLP, same room, same furnitures before and after creating IR filters and applying filters with CamillaDSP? Does it takes a separate computer with REW?
I'm asking because I took a new set of measurements and made certain by monitoring with helvum and Camillagui that the measurement signals from REW were routed through the speaker filters. I compared that with my initial measurements I made 1 day earlier without any DSP treatment.
I expected to see what should have been corrected (A/B). Since I can hear the diffference, and it's hige, I imagine I would see it too. To my surprise, the curves were identical. Once smoothed to 1/6, they were still perfectly superimposed!
Am I missing something?
