mcbrains001
Registered
Thread Starter
- Joined
- May 22, 2023
- Posts
- 4
More
- Preamp, Processor or Receiver
- Denon 3800h
- Front Speakers
- Acoustic Audio
- Center Channel Speaker
- Acoustic Audio
- Surround Speakers
- Acoustic Audio
- Surround Back Speakers
- Acoustic Audio
- Front Height Speakers
- Acoustic Audio
- Rear Height Speakers
- Acoustic Audio
- Subwoofers
- 2 SVS PB 2000 Pro
- Screen
- 141 Silver Ticket AT Screen
- Video Display Device
- JVC NZ7
H everyone!
Ignore my lack of knowledge, please. I have gone through setting REW with Umik-1. I have a 7.2.4 set up. All my bed-layer speakers are going through an external amp (OSD Nero XA7180). I have installed REW and ASIO4ALL as well and running the setup using a HP Spectre laptop/Lenovo laptop. I mentioned 2 laptops because after my initial setup on the HP, I tried to check levels and i am not getting any output. The same happened with Lenovo as well. I n my setup, I went into the ASIO control panel and then selected the input and output devices.
My laptop sees the Denon AVR as "Denon AVR -HD audio for display audio"
I can not find any option in setting multichannel on the laptop like Mac has.
Please advise.
Thanks
Ignore my lack of knowledge, please. I have gone through setting REW with Umik-1. I have a 7.2.4 set up. All my bed-layer speakers are going through an external amp (OSD Nero XA7180). I have installed REW and ASIO4ALL as well and running the setup using a HP Spectre laptop/Lenovo laptop. I mentioned 2 laptops because after my initial setup on the HP, I tried to check levels and i am not getting any output. The same happened with Lenovo as well. I n my setup, I went into the ASIO control panel and then selected the input and output devices.
My laptop sees the Denon AVR as "Denon AVR -HD audio for display audio"
I can not find any option in setting multichannel on the laptop like Mac has.
Please advise.
Thanks