linuxonly
Member
Thread Starter
- Joined
- Jul 27, 2024
- Posts
- 112
More
- Preamp, Processor or Receiver
- Logitech Z906
- DAC
- AMD FCH Azalia
- Computer Audio
- SPDIF output with alsa, pipewire, wireplumber on Fedora 40
- Streaming Equipment
- Kodi
- Front Height Speakers
- 33 in
- Middle Height Speakers
- 30 in
- Rear Height Speakers
- 57 in
- Video Display Device
- X11/VGA + X11/DVI
Hi,
Let's suppose I took measurements with the UMIK pointing towards the ceiling but used the flat mic cal file.
To remove the cal file influence on the L measurement, is it correct to import the flat cal file as F then generate |L|/|F| as L1 ?
Then to correct the measurement with the 90deg cal file, import the 90 deg cal file as C then generate |L1|/|C| as L2 where L2 would be the left measurement with the 90 cal file correction properly applied?
Let's suppose I took measurements with the UMIK pointing towards the ceiling but used the flat mic cal file.
To remove the cal file influence on the L measurement, is it correct to import the flat cal file as F then generate |L|/|F| as L1 ?
Then to correct the measurement with the 90deg cal file, import the 90 deg cal file as C then generate |L1|/|C| as L2 where L2 would be the left measurement with the 90 cal file correction properly applied?
