jschwender
Member
More
- Front Speakers
- Nubert digital pro
- Other Speakers
- Philips dss940
If i do an SPL measurement, set the units in the "SPL & Phase" tab to V or W, then the phase scale disappears. It reappears if i change the units to any other unit.
Secondly, if i change to any other tab, and go back to "SPL & Phase" the unit is reset to SPL, no matter what it was before. This does not happen with other tabs, there the units are "sticky", which is in my opinion expected.
Third, if i go to "Controls" and add a SPL offset, that is effective only if the unit is SPL. I wonder if this is expected? If it is not, it would be nice if the setting was grayed out in cases is does not work. I find it useful if i was able to correct also measurements in dBV or even in V by an offset.
Secondly, if i change to any other tab, and go back to "SPL & Phase" the unit is reset to SPL, no matter what it was before. This does not happen with other tabs, there the units are "sticky", which is in my opinion expected.
Third, if i go to "Controls" and add a SPL offset, that is effective only if the unit is SPL. I wonder if this is expected? If it is not, it would be nice if the setting was grayed out in cases is does not work. I find it useful if i was able to correct also measurements in dBV or even in V by an offset.
