Error During Measurement Using exaSound s88 DAC

[sledwards]

I have setup a 6-channel measurement (2 mains and 4 subs) using separate input and output devices, Mic in is thru a Focusrite Scarlett USB using Focusrite AISO driver. Output thru the DAC uses exaSound 8-channel AISO64 driver:

I am able to perform 'Check Speaker Connections' without any issues. When I 'Run Measurement', I get the following Windows error:

Any suggestions would be helpful. Hopefully my fallback is not having to buy an 8-channel sound card with combined input/output.

Regards,
Steve

 

[Omid]

Try different combination of drivers rather than ASIO for both playback and input.

 

[e1guapo]

You can’t use two ASIOs at once. You can ether use one ASIO + one WDM or use ASIO4ALL for two different devices.

 

[sledwards]

Good catch e1guapo, I had learned that earlier but forgot. Unfortunately I have another issue. To actually get it to perform sweeps, I had to increase the channel count from 6 to 8, even though I had no output on two of my channels. It then failed the quality check, I assume because of the two null outputs. Oh and BTW, AISO4ALL does not work for output.