REW with MiniDSP on SVS PB12-NSD and PB2000 newbie help

[stryderlis]

Hi all - i'm using REW with a Umik to measure my room and using the MiniDSP along with REW PEQ corrections. The graphs are not showing much improvement after I use the EQ filters. As you can see there were some minor changes on the low end but I was expecting more for some reason. Any advice would help me as i'm a total new at this.

Please see my thread at the minidsp forum asking for help.

https://www.minidsp.com/forum/software-support/14906-2-subs-minidsp-2x4-setup-advice