REW Beta Release REW API beta releases

majorwong

Registered
Joined
Mar 8, 2023
Posts
2
Hi,

John Mulcahy

4 more suggestions for you to add in REW:
1.Would you think of adding an unit of exportation of group delay,which can be imported in other simulation tools?
2.Measure the SPL and Imp,adding a sweep signal range from 20kHz~20Hz(from high to low) might increase stability of the test result just like soundcheck.To some extent it may reduce the 'hush' sound annoying during the test.
3.A brown theme like sunset should be considered to put into TO-DO-LIST.
4.Volume or adding mass method should show the optimal fs shift percentage(20%~50%) after 2 curves overlay,which can get rid of the manual calculation.

Thanks for your reply.​

 

Attachments

  • 1.png
    1.png
    10.9 KB · Views: 1

newbiejl

Registered
Joined
Oct 23, 2024
Posts
1
Hi, I couldn't figure out the body (REST API) to set "Mic cal files" where "separateCalFileForEachInput" =true.
Have anyone tried this?
Thanks!

Here's my PUT/audio/input-cal
{
"currentInputSelection": "Microphone (E.A.R.S Gain: 24dB ) MICROPHONE (Master Volume)",
"separateCalFileForEachInput": true,
"inputDeviceIsCWeighted": false,
"calDataAllInputs": {},
"perInputCalData": {
"L":{
"calFilePath": "C:\\Users\\xxxx\\Downloads\\L_RAW_xxxx.txt"
},
"R":{
"calFilePath": "C:\\Users\\xxxx\\Downloads\\R_RAW_xxxx.txt"
}
}
}

======================================================================
But while setting up manually on the REW interface, GET input-cal will show:
{
"currentInputSelection": "Microphone (E.A.R.S Gain: 24dB ) MICROPHONE (Master Volume)",
"separateCalFileForEachInput": true,
"inputDeviceIsCWeighted": false,
"perInputCalData": {
"L": {
"calFilePath": "C:\\Users\\xxxx\\Downloads\\L_RAW_xxxx.txt",
"dBFSAt94dBSPL": -20.38971
},
"R": {
"calFilePath": "C:\\Users\\xxxx\\Downloads\\R_RAW_xxxx.txt",
"dBFSAt94dBSPL": -20.38971
}
}
}

Seems like the current API doesn't support "separateCalFileForEachInput": true
Any thoughts?
 
Last edited:
Top Bottom